The text below This section describes how to enter subpart D Electricity Generation fuel information for
a specific unit. Note that fuel information should be entered for each unit at your facility. The process to edit
existing fuel information
for an existing unit is essentially similaris identical.
Adding or Updating Fuel Information for Each Unit
...
{composition-setup}{ Composition Setup |
}
...
{
:=} Click image this link to expand Image RemovedImage Added Cloak |
---|
Wiki Markup |
---|
{cloak:id=PNG1|cloak.toggle.zone | true |
---|
id | PNG1 |
---|
| | =none|cloak.toggle.zone=true}
Panel |
---|
Image Removed |
Starting on the Subpart D Overview page, find the configuration type unit for which you would like to enter emissions fuel information in the UNIT-LEVEL SOURCE SUMMARY table and click the OPEN button on the right side of the page that corresponds to the unit that will be edited.
Wiki Markup |
{
:=} Click this link Click image to expand Image RemovedImage Added Cloak |
---|
Wiki Markup |
---|
{cloak:id=PNG2|cloak.toggle.zone | true |
---|
id | PNG2 |
---|
| | =none|cloak.toggle.zone=true}
Panel |
---|
Image Removed |
To add a fuel type for this configuration, click the “ADD a Fuel” link below the FUEL SPECIFIC CH4 AND N2O EMISSIONS INFORMATION table.
Wiki Markup |
---|
{toggle-cloak:id=PNG3} |
Click image to expand Image Removed. Additionally, existing fuels that are no longer used can be deleted by clicking the red X button on the right side of the page that corresponds to the fuel that will be deleted.
Click this link to expand Image Added Cloak |
---|
Wiki Markup |
---|
{cloak:id=PNG3|cloak.toggle.zone | true |
---|
id | PNG3 |
---|
| | =none|cloak.toggle.zone=true}
Panel |
---|
Image Removed |
Excerpt |
---|
For each unit, subpart D requires the facility to report each type of fuel combusted in the configuration during the reporting year (for Table C-2 fuels only) [98.36(d)(1)(iii)]. |
Use the radio buttons to select a fuel type for this unit.When finished, click SAVE.. Repeat the above procedure for all fuels combusted at each unit at your facility. Once you have entered the required fuel information for all fuels at all Subpart D units at your facility, you will have finished entering the required fuel information for your facility.
#Back Back to Top
See Also
Screen Errors
Using e-GGRT to Prepare Your Subpart D Report
Subpart D Unit Information
Subpart D Unit Emissions and Missing Data Information
Subpart D Fuel Emissions and Heat Input Information
Subpart Validation Report