Subpart K Emissions Information for Furnaces NOT Monitored by CEMS


This page provides step-by-step instructions on how to enter and edit Subpart K Ferroalloy emissions information for electric arc furnaces (EAFs) that are NOT monitored by a Continuous Emissions Monitoring System (CEMS).

Step 1: Select a unit

To select a unit for which to enter emissions data, find the unit in the ELECTRIC ARC FURNACES table and click OPEN.

Click this link to expand

Step 2: Equation K-1 and K-3 Summary and Result

For each EAF that is NOT monitored by CEMS at your facility, Subpart K requires the following emissions information:

  • The annual CO2 process emissions (the output of Equation K-1, in metric tons)
  • For each EAF used for the production of a ferroalloy listed in Table K-1, the annual CH4 process emissions (the output of Equation K-3, in metric tons).

For RY2014 and later each of the values are developed by entering your equation inputs data into the Inputs Verifier Tool (IVT) and letting the IVT calculate your emissions.  If you disagree with the emission value calculated by IVT you will have an opportunity to override and enter your own value after IVT has done its calculations. 

Click on the green "GO" button labeled "Use Inputs Verifier to calculate" to open the IVT page where equation inputs are entered.  For help related IVT for Subpart K click Subpart K Entering Equation Inputs Using IVT.

Click this link to expand

Step 3: Enter Measurement Method and Missing Data Procedure Information

In addition to the emission of CO2 and CH4 you must also provide the following measurement method and missing data procedure information for each input and output assigned to an electric arc furnace:

  • The method used to determine carbon content (Provided by supplier, ASTM E1941-04, ASTM D5373-08, or ASTM C25-06)
  • An indication if a missing data procedure was used or analysis was repeated to determine carbon content
  • The procedure used to develop substitute data for monthly mass, if applicable (Purchase records or Other)
  • The number of months that missing data procedures were followed to determine monthly mass

Your completed Subpart Input and Outputs page should look the screen snap below after these steps.

Click this link to expand

Step 4: Save Your Data

When you have finished entering inputs for Equations K-1 and K-3 and Input/Output data, click SAVE. You will then be directed back to the Subpart Overview page. The status of data entry for this furnace in the ELECTRIC ARC FURNACES table should now be “Complete” in the Status column.

After you save the data on this page, the next time you open the page, the calculator on the top of the page will display the CO2 and CH4 process emissions, rounded to the nearest 0.1 and 0.01 of a metric ton, respectively. The value displayed is for informational purposes only.

Step 5: Repeat steps 1-4

Repeat Steps 1-4 until emissions and input/output data has been entered for all EAFs NOT monitored by a CEMS. Once you have entered the emissions information, that status of data entry for all furnaces in the ELECTRIC ARC FURNACES table should now be “Complete” in the Status column. If you have missed something, the validation report messages will help you identify any incomplete entries.

Back to Top

See Also

Screen Errors
Using e-GGRT to Prepare Your Subpart K Report
Subpart K Summary Information for this Facility
Subpart K Furnace Information for Furnaces NOT Monitored by CEMS
Subpart K Furnace Information for Furnaces Monitored by CEMS
Subpart K Emissions Information for Furnaces Monitored by CEMS
Subpart Validation Report

This web site is maintained by a contractor to the U.S. Environmental Protection Agency (RY2023.R.01)