...

To delete an EAF, click the delete icon or red "x" “x” located in the last column of the table.

{composition-setup}{composition-setup}

{toggle-cloak

:id

=PNG1}

{cloak:id=PNG1|cloak.toggle.type=none|cloak.toggle.zone=true}

{cloak}

Step 2: Indicate CEMS utilization for a furnace

...

Note that when adding a new EAF you are prompted to answer the CEMS question immediately (the answer to this question will default to "No" “No” for EAF added using the "ADD “ADD a Furnace" Furnace” link and will default to "Yes" “Yes” for units added using the "ADD “ADD a Furnace Monitored by CEMS" CEMS” link).

The CEMS response may be changed here and the EAF information will be relocated to the appropriate table on the Subpart Overview page.

When finished, click SAVE. You will then be directed to the next Add/Edit a Unit form.

{toggle-cloak

:id

=PNG2}

{cloak:id=PNG2|cloak.toggle.type=none|cloak.toggle.zone=true}

{cloak}

Step 3: Enter required information for an EAF

...

When you are finished entering the required information for an EAF, click SAVE. You will then be direct back to the Subpart Overview form. You should now see the furnace you just identified listed in the ELECTRIC ARC FURNACES (Furnaces Monitored by CEMS) table.

{toggle-cloak

:id

=PNG3}

{cloak:id=PNG3|cloak.toggle.type=none|

cloak.toggle.zone=true}

{cloak}

Step 4: Repeat Steps 1-3

Repeat Steps 1-3 until all EAFs have been added for your facility and you see all EAFs monitored by CEMS listed in the ELECTRIC ARC FURNACES (Furnaces Monitored by CEMS) table.

...