Greenhouse Gas Reporting Help

Associated Gas Venting and Flaring

Created by Matthew R. Hill, last modified by Help Content Reviewer on Feb 06, 2015

Please see Reporting Form Instructions on downloading the blank reporting form and uploading the completed reporting form.
You may also refer to Optional Calculation Spreadsheet Instructions to download the Subpart W calculation spreadsheet.

This page provides an overview of the Subpart W associated gas venting and flaring source category e-GGRT reporting requirements.

The associated gas venting and flaring source category is applicable to Onshore Petroleum and Natural Gas Production.

Indicate if the facility has the source type via the radio buttons.

If the source type is present you must report required elements.

If the facility has the source type, the Best Available Monitoring Methods and Missing Data table must be completed.

For further information, see Best Available Monitoring Methods and Missing Data Reporting.

Reporting Requirements

For associated gas venting and flaring, the facility is required to report:

The unique identity of the basin (98.236(c)(11)) - this data element is automatically populated using data from the Sub-Basin Selection tab. Please verify that the basin ID is correct.
Number of wells venting associated gas in a calendar year (98.236(c)(11)(i))
Number of well flaring associated gas in a calendar year (98.236(c)(11)(i))
Average gas to oil ratio for the basin (98.236(c)(11)(ii))
Total annual CO₂ emissions for the entire facility from associated gas venting (98.236(c)(11)(iii))
Total annual CH₄ emissions for the entire facility from associated gas venting (98.236(c)(11)(iii))
Total annual CO₂ emissions for the entire facility from associated gas flaring (98.236(c)(11)(iv))
Total annual CH₄ emissions for the entire facility from associated gas flaring (98.236(c)(11)(iv))
Total annual N₂0 emissions for the entire facility from associated gas flaring (98.236(c)(11)(iv))

Total Emissions

The total emissions roll-up at the top of the sheet reflects the sum of the CO₂ equivalents of each gas emission reported for the source type. These summations are reflected and aggregated on the Introduction tab.