...

To delete a unit, click the delete icon located in the last column of the HYDROGEN PROCESSING UNITS (Units monitored by CEMS) table

{composition-setup}{composition-setup}

{toggle-cloak

:id

=PNG1}

{cloak:id=PNG1|cloak.toggle.type=none|cloak.toggle.zone=true}

{cloak}

Step 2: Indicate CEMS utilization for a unit

...

Note that when adding a new unit you are prompted to answer the CEMS question immediately (the answer to this question will default to "No" “No” for units added using the "ADD “ADD a Unit" Unit” link and will default to "Yes" “Yes” for units added using the "ADD “ADD a Unit Monitored by CEMS" CEMS” link)

The CEMS response may be changed here and the unit information will be relocated to the appropriate table on the Subpart Overview page

When finished, click SAVE

{toggle-cloak

:id

=PNG2}

{cloak:id=PNG2|cloak.toggle.type=none|cloak.toggle.zone=true}

{cloak}

Step 3: Enter required information for a unit

For each process unit monitored by a CEMS, report the following required information:

• Wiki MarkupA unique name or identifier for the unit, plus optional description for this unit (see also About Unique Unit Names) \ [98.166(a)(1) and 98.166(b)(1)\]
• Wiki MarkupThe quantity of hydrogen produced (in metric tons) \ [98.166(a)(2) and 98.166(b)(3)\]unmigrated-wiki-markup
• The quantity of ammonia produced (in metric tons) \ [98.166(a)(3) 98.166(b)(4)\]

When finished, click SAVE

{toggle-cloak

:id

=PNG3}

{cloak:id=PNG3|cloak.toggle.type=none|

cloak.toggle.zone=true}

{cloak}

Step 4: Repeat Steps 1-3

Repeat Steps 1-3 until all process units monitored by a CEMS have been added for your facility

...