The text below describes how to enter subpart D Electricity Generation fuel emissions information for each unit at your facility. The process to edit fuel emissions information for an existing unit is essentially similar.
Click image to expand Cloak |
---|
cloak.toggle.zone | true |
---|
id | PNG1 |
---|
cloak.toggle.type | none |
---|
|
|
Starting on the Subpart D Overview page, find the configuration type for which you would like to enter emissions information in the SOURCE SUMMARY table and click OPEN.
Click image to expand Cloak |
---|
cloak.toggle.zone | true |
---|
id | PNG2 |
---|
cloak.toggle.type | none |
---|
|
|
To enter emissions data by fuel type, find the fuel type for which you would like to enter fuel emissions data in the FUEL-SPECIFIC CH4 AND N2O EMISSIONS INFORMATION table and click OPEN.
Click image to expand Cloak |
---|
cloak.toggle.zone | true |
---|
id | PNG3 |
---|
cloak.toggle.type | none |
---|
|
|
Cal e-GGRT will calculate the following required data based on provided inputs:
Wiki Markup |
---|
The total annual CH{~}4~ mass emissions derived from Equation C-10 in metric tons CH{~}4~ and in metric tons CO{~}2{~}e. \[98.36(b)(9)(iii), 98.36(c)(2)(ix)\] |
Wiki Markup |
---|
The total annual N{~}2{~}O mass emissions derived from Equation C-10 in metric tons N{~}2{~}O and in metric tons CO{~}2{~}e. \[98.36(b)(9)(iii), 98.36(c)(2)(ix)\] |
Use the radio buttons to elect to report emissions using the Cal e-GGRT calculated value or to enter your own value manually. If you elect to report manually calculated emissions values, use the the appropriate radio buttons and data fields. Otherwise, the radio buttons will default to using the calculated results.
When finished, click NEXT.
Click image to expand Cloak |
---|
cloak.toggle.zone | true |
---|
id | PNG4 |
---|
cloak.toggle.type | none |
---|
|
|
Use the Equation Inputs to enter required inputs:
- Cumulative annual heat input from fuel combustion
- Annual mass or volume of fuel combusted
- Emission factor (if the fuel was entered manually)
When finished, click NEXT. On the Fuel-specific Emissions screen, click FINISHED to save the data entered for this fuel.
Once you have entered the required fuel emissions information for all units at your facility, you will have finished entering the required fuel emissions information for your facility.
#Back to Top
Screen Errors
Using e-GGRT to Prepare Your Subpart D Report
Subpart D Unit Information
Subpart D Unit Emissions Information
Subpart D Fuel Information
Subpart Validation Report